Mamiya C33 Professional Manual de usuario

www.orphancameras.com

your convenience: align the yellow mark with the white mark on the camera bodv foreasy removal of fiIm. (Fig. 15)6. Red window cover @ can be slid

CHANGING FOCUSING HOOD1. The focusing hood can be easily removed by loosening the lockscrew @ and lifting up the rear end of the assembly.2. T

xr.522.53oFigures given on the left side of the ground glass show exposureindex. If the reading of the scale is 2 with object in focus, thisi

index; lines on the right side are for parallax. If the indicator needle points to 1.5, thesection of picture above the top line will be cut off.

1.SINGLE EXPOSURE PHOTOGRAPHYTurn multiple exposure/filmstop selector @ to "SHEET or Multi-exp". At this position the shutter button can be

the PORROFLEX.2- Set the synchroflash M-X selector @ for the type of flash used. This acljustment may bedone after the shutter has been cocked.

INTERCI{ANGEABIE LENS.SHUTTER ASSEMBLIES(MAMIYA-SEKOR lens with SEIKOSHA-S shutter)WIDE-ANGIE (F3.5, f :65mm, 63-degree picture angle)A 6-element, S-

reflex cameras using lenses of. 75mm focal length or thereabouts. This fully correctedanastigmat is eminently suitable for portraiture, commercia

SPECIAL ACCESSORIESLENS HOODS Four types are availablefor 65 mmGAUTION :for 80 rnm and 105 mmfor 135 mm1. When attaching the hoods for the 135mm an

FIITERS (by TOSHIBA)Filters of various types are available in three slzes:40.5mm diameter screw-in type for the 80mm and 105mm lenses46 mm diameter sc

MAMIYA C33Professionol0liltER's MAltl|[twww.orphancameras.com

S!NGLE-EXPOSURE ATTACHMENTBy using the single-exposure back in place of the standard backlid,the special plate and cut film holders permit the taki

NAME OF OPERATI'VG PO//NTs1. Magnifying Glass2. Focusing Hood Front3. Frame Viewfinder (for80mm lens)4. Frame Viewfinder MaskStuds (right and le

14. Parallax Correction Lever15. Filmspeed (ASA) Dial16. Shutter Cocking Lever(body assembly)L7. Shutter Cocking Lever(lens-shutter assembly)18. Synch

FOCUSING HOOD OPERATION1. The focusing hood will snap erect when the fobusing hood front @ is lifterl up from therear. (Fig. l)2. Slight pressure on

5.plate. (Fig. 4)To collapse and fold the focusing hood, first see that the framethen fold down the magnifying glass O. Fold down the sidemomentarily

and allow it to swing out forward. The lens-shutter assembly can then be lifted out. (Fig. 7)5' To attach a lens-shutter assembly, lower carefull

FIIM TOADING1. To open backlid, first turn backlid catch button @ so that the red dot isthen push to the right, in the direction indicated by the arro

arrow) printed on the paper backing of the film comes into alignmentwith the start marks @ near the upper side of the film gate (Fig. 12).Close backl