Mamiya 645 AFD III Especificaciones descargar pdf (Pagina 17)

33 34

If you do not operate the camera for 60 seconds, the camera will automatically enter

the sleep mode in order to save battery power. In the sleep mode the camera will not

automatically wind the film to the 1st frame, even if the custom setting is enabled (C-

31 on page 94). In this case, press the shutter release button halfway down to feed

the film to the 1st frame position.

8. Close the back cover.

Push in the upper part of the back cover firmly

to close it.

After attaching the magazine onto the camera

body, pull out the dark slide and press the

shutter button halfway; this will feed the film

automatically to frame No. 1.

Place the dark slide in the magazine's rear

storage pocket.

7. Insert the loaded film insert into

the magazine.

While squeezing the center latches together,

place the film insert, with the feed spool on top,

in the magazine and with pressure on the left

and right blocks push it into proper position.

(You will hear a click).

6. Attach the leader paper of the

film to the empty spool.

As shown in the figure left, gently insert the

leader paper tip into the groove on the empty

spool that is on the “SPL” side, and turn the

spool one or two turns to wrap the leader tape

around it. It is not necessary to finely adjust the

position of the film’s starting edge manually as

the film will be wound into the correct position

automatically.

Turn the spool tight so that the film does not

sag.

When the film is not wound properly, the “- - ” mark appears in the LCD.

Do not wrap too much leader paper around the empty spool. Otherwise the film sec-

tion may be exposed to light.

To prevent accidental film fogging, do not pull out the leader paper too far or load/

unload film under direct sunlight.

Make sure that the film insert is properly fixed. When one or both white latches are

out of position, press the projecting portion or until it clicks.

6-exposure film

If you take more than 8 pictures when using a 6-exposure film, the shutter

blades may be damaged by the leader paper at the film end or by the film tape.

Follow the procedure below.

Photograph in the same way as with 120 film. Eight exposures can be taken.

After taking the 8th exposure, insert the dark slide in the magazine.

Then hold down the emergency film wind button and half-press the shutter re-

lease button.

1. The camera can be set to wind the film to the 1st frame position

automatically after the back cover is closed.

Custom settings (C-32 on page 94)

2. Normally, after the rear cover is closed the shutter cannot be released

without any film in the camera. However, the camera can be set to allow

you to release the shutter without any film.

Custom settings (C-31 on page 94)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

Comentarios a estos manuales

Sin comentarios

Mamiya 645 AFD III Especificaciones Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Cámaras Bridge Mamiya 645 AFD III